ADS-TEC VMT7010/7012/7015 User Manual
Page 40
VMT7010/VMT7012/VMT7015
39
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
Touch screen driver installation
Information:
When installing the driver, you'll have to take in account that the touch
screen monitor is internally connected with the USB interface!
The installation has to be carried out as described below:
The device does not have any integrated CD drive. The installation of the operating system can
therefore only be carried out by using the USB interface.
Access the service CD by using the Explorer and start the Installer file in the
TouchScreen folder.
Follow the on-screen instructions and acknowledge the licence terms and
conditions.
Once the installer has completed the installation, shut down the computer and
restart it subsequently.
After restarting, the touch screen monitor has to be calibrated. If the driver
does not automatically start, activate the setup menu via "Start => Settings =>
Control panel => Elo Touchscreen".
Via the "Calibration data" menu, calibrating the touch screen monitor can be
started, and the crosses appearing in a succession on the monitor have to be
pushed for calibration. If the cursor position perfectly matches the touch point
of your finger, you can exit this control menu by pushing "OK".