ADS-TEC VMT7010/7012/7015 - Manual (Page 39)

VMT7010/VMT7012/VMT7015 38
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
8 Software & driver installation
The device will be delivered with a pre-installed Windows operating system depending on what the
customer wants. The drivers required for this, are already installed and the operating system will be
enabled by entering the licence information. Should an initial installation be required, please follow the
following steps. With a newer operating system, the network card and graphics card will properly be
recognised during the initial installation, so that only the touch screen driver and the soft keyboard must
be installed separately.
Information:
If the hard drive was formatted, the operating system can be reinstalled by
using one of the existing interfaces.
An external keyboard is required for installation.
Installing the operating system
The device does not have any integrated CD drive. The installation of the operating system can
therefore only be carried out by using the USB interface.
Procedure for installation:

The boot drive in the system Bios must be switched to USB in order to boot
the device from the USB interface.

Restart the device and insert a Windows CD.

Install Windows and set up the basic data.

With devices including touch screens, the touch screen driver as well as the
soft keyboard should be installed in order to ensure their full functionality.
With Windows 7 embedded or Windows XP embedded, a complete image can also be installed by
using a USB stick.
Pos : 37 /D atent ec hni k/Sof t war e / Trei ber Install ati on/Touc h Screen/Touc h Screen I nst allation f ür OPC 5112/ 5212/ 5315/ 5515/ 5317 /5319 / C PC 5006/OTC 5006/ VMT-Serie @ 0\ mod_1159175108636_6. doc @ 665 @