ADS-TEC RAC2000 User Manual - Manual (Page 18)

RAC2000 series 17
© ads‐tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden‐Echterdingen
4.2.2 Status display activities when resetting to default settings
By using the default setting button on the rear of the device, the RAC2000 can be reset to the default settings
regardless of the configuration.
The default setting button must be pushed, and the device then be switched on, in order to reset the device to
the default settings. The default setting button must be pushed for approx. 20 seconds. As soon as both HOST
LEDs flash, you can release the button. No HOST cable is connected in this example. By means of the following
diagram, the correct factory default process can be traced by watching the flashing frequency of the LEDs.
WLAN (1) / (2) Signal Action
Left LED Link Device is searching for available WLAN
networks.
HOST Signal Action
Left LED Link LEDs blink twice briefly
Rechte LED Link LEDs blink twice briefly
Lft LED ACT LED turns out
Right LED ACT LED turns out
POWER Signal Action
The device is supplied with power via
Power and is ready