ADS-TEC RAC2000 User Manual - Manual (Page 9)

RAC2000 series 8
© ads‐tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden‐Echterdingen
2.2 Operation Location
This device is designed for use in industry. You must ensure compliance with the specified environmental
conditions. Using the device in non‐specified environments, e.g. on board ship or in areas containing explosive
vapours, gases or gas mixes, as well as in extreme heights, is prohibited.
Warning:
If this device is used outdoors, it must be located inside the protective area of a
lightning arrester. You have to make sure that all conductive systems introduced
from outdoor areas and connected to the device are equipped with a lightning
arrester/potential equalisation system.
This device may only be switched on after the required ambient temperature is
reached in order to avoid condensate accumulation. The same applies if the device
has previously been exposed to extreme temperature variations.
To avoid overheating in operation: Do not expose the device to any direct radiation
by sunlight or any other light or heat source.
Warning:
This is a Class A device. In a domestic environment this device may cause radio
frequency (RF) interference, in which case the user may be required to take
adequate measures.
Warning:
To avoid personal injury resulting from RF energy, a minimum distance of 20 cm
must be maintained to the device
Warning:
For the prevention of water condensate accumulation, the unit should be turned ON only
when it reaches ambient temperature. This particularly applies when the unit is subject to
extreme temperature fluctuations and/or variations.
Avoid overheating during unit operations; the unit must not be exposed to direct
sunlight or any other direct light or heat sources.
2.3 Damage Caused By Improper Use
This device must immediately be shut down and protected from any accidental commissioning if the operating
system shows any obvious damage caused by, for example, improper operating or storage conditions, or by
improper use or handling.
2.4 Warranty / Repair
During the warranty period, any repair must only be carried out by the manufacturer or by a person authorised
by the manufacturer.