ADS-TEC RAC2000 User Manual - Manual (Page 24)

RAC2000 series 23
© ads‐tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden‐Echterdingen
5.2 Manual Network adapter configuration
Note:
The notes below have been created by using Windows XP®. Should you use a
different operating system, the directory paths and properties described here
might vary.
Open the Properties tab of the network adapter you are using. The directory path is:
Start> Settings> Network connections> LAN connections> Properties.
Select the following option in the pop‐up dialogue: Internet protocol (TCP/IP); then click on Properties .
Abb. 7:
Here select the following item: Use following IP address
Access to the device will only be enabled once the following parameters have been entered as the fixed IP
address, or if the computer is located in the same subnet area:
IP Address: 192.168.0.100
Note:
(The last section of digits must represent a number between 1 and 253; the value " 100"
was selected in the example)
Once the IP address is entered, you have to input the Subnet mask address. If you click into the Subnet mask box,
the correct address is automatically entered.
Subnet Mask: 255.255.255.0
You can now close the dialogue boxes by pushing the "OK" button.