ADS-TEC RAC2000 User Manual - Manual (Page 27)

RAC2000 series 26
© ads‐tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden‐Echterdingen
5.4 Calling up the Device Web Interface
To access and open the device web interface, start up your web browser. In the browser’s address bar, enter the
following IP address then confirm with Enter
http://192.168.0.254
Login
Once the IP address has been entered with success, the login prompt appears. In the login prompt, entry of the
default settings is required.
The default configuration in just‐delivered conditions is:
User Name : admin
Password : admin
Confirm your entries by clicking on: OK
Abb. 11:
Note:
If the login prompt does not appear, check to ensure that the device has been connected
via a RJ45/LWL optic fibre connection cable. Otherwise, connect the device up to a PC
(Device LAN‐in/LAN‐out connection <> PC LAN connection).
If there still is no connection to the firewall login prompt, it is necessary to check the proxy
and local firewall settings. It often occurs that also local subnet addresses ( e.g.
192.168.x.x) are diverted to a proxy server. In this case it is possible to select the “Bypass
proxy server for local addresses” option to enter the address in question.