AirLive AirMax5N-ESD - Manual (Page 19)

2. Installing the AirMax5N
AirLive AirMax5N/ESD User’s Manual
13
2.4.1 Standard Pole Mount
Your AirMax5N comes standard with 1 plastic straps for pole mounting. Please follow the
procedure below to install:
1. Put the plastic strap through the holes
on the Pole Mount holders.
2. Thread the thinner end of the strap into
the opening on the other end. Then
tighten the strap around the pole as
tightly as possible.
2.4.2 Installing External Antenna
The AirMax5N is equipped with a 16dBi built-in patch antenna. It has horizontal coverage
angle of 30 and vertical coverage angle of 20 degree in the forward direction. If the built-in
antenna cannot meet your requirement, you can connect AirMax5N with an external
antenna via the Female R-SMA connector.
Before you start, you would need an antenna converter cable. For example; if you want to
connect directly to an outdoor antenna with female N-Type connector, you would need a
Male R-SMA to Male N-Type connector. Please note that you should not connect the power
until the external antenna is attached to avoid damaging the RF
.
Once you have the converter cable, please follow the installation steps below.