AirLive AirMax5N-ESD - Manual (Page 33)

4. Web Management-Wireless and WAN Settings
AirLive AirMax5N/ESD User’s Manual
27
Add (to WDS): Please choose a SSID before click on this button. This button is
available only in Client, WDS or WDS + AP modes. Once you click on this button,
AirMax5N will attempt to make a connection with the selected network. If there is
encryption needed, the AirMax5N will prompt you to enter the encryption key. Please
make sure you enter the correct encryption key, the AirMax5N will not check whether
the encryption key is correct.
Signal Strength: This is a value to show the signal level of the AirMax5N. In general,
remote APs with stronger signal will display higher level.
4.2.3 Radio Mode (11a, 11a/n mixed, 11n)
Operation Mode -> Setup -> Radio Mode
AirMax5N has 3 different options for WLAN transmission.
4.2.4 Channel
Operation Mode -> Setup -> Channel
The channel available for use in your device depends on your country’s regulations. This
is subject to change depending on regulations of your country. Your device is preloaded
with firmware according to the regulations. If your device’s firmware is not conforming to
your country’s latest regulation, please write to
[email protected] .
4.2.5 Channel Width
Operation Mode -> Setup -> Channel Width
Each channel will jump by number of 4 (i.e. 36, 40, 44…etc). You can change the Channel
Width to 20 or 20/40MHz to either increase performance or reduce the interference
problem.
Click here to select
SSID for Association
or Signal Survey
To connect with the
selected SSID. This
function is available only
in Client or Bridge Mode
For antenna
alignment. It will
display signal value
once a second.