AirLive CW-720 - Manual (Page 32)

4. Monitor the Image Section
27 AirLive CW-720 User’s Manual
SSID:
This is the name of the wireless network the device is configured for. The field accepts up to
32 alphanumeric characters. The name must be exactly the same as that used in the
wireless access point, or the connection will not be established.
Leaving this field blank means the device will attempt to access the nearest open network.
Channel:
Chooses the wireless channel in use currently.
WEP settings:
- Authentication:
Select Open or Shared Key System Authentication, depending on the method used by
your access point. Not all access points have this option, in which case they probably
use Open System, which is sometimes known as SSID Authentication.
- WEP Mode:
The key types available depend on the access point being used. The following options
are available:
•ASCII - In this method the string must be exactly 5 characters for 64-bit WEP and
13 characters for 128-bit WEP.
•HEX - In this method the string must be exactly 10 hexadecimal (0-9, A-F)
characters for 64-bit WEP and 26 hexadecimal characters for 128-bit WEP.
- Web Key 1~4:
Key value of WEP.
WPA settings:
- WPA Key:
Key value of WPA. The device uses a pre-shared key (PSK) for key management. The
pre-shared key can be entered either as Manual hex, as 64 hexadecimal characters, or
as a Passphrase, using 8 to 63 ASCII characters.
Obtain IP address automatically (DHCP):
Enable this checked box when a DHCP server is installed on the network to issue IP
address assignment. With this setting, the IP address is assigned automatically.
IP address, Subnet mask, and Gateway:
If you do not select Obtain an IP address automatically, then you need to enter these
network parameters manually.
Select “OK” to save and enable the setting.