AirLive CW-720 - Manual (Page 48)

4. Monitor the Image Section
43 AirLive CW-720 User’s Manual
DIPS (Dynamic IP Service):
To enable or disable the DIPS® (Dynamic IP Service) function.
Device ID (for DIPS):
It’s a unique number of each device for identification and this ID is used for DIPS.
In the Appendix G, it describes how to locate your device from Internet by DDNS service.
However, we provide another easier way to do the same job called Dynamic IP Service,
DIPS®.
To use this service, just follow four steps below:
(1) Enable DIPS function of the device
(2) Check your Device ID from this page. This is a unique number for each device.
(3) If your device is behind a NAT router, please configure your device properly. You
could refer to section “Install the Camera behind a NAT Router” above. You only need
to do this job one time.
(4) Visiting our company’s web site, you can find DIPS service page as below:
Enter your Device Number and press “OK” button.
Then, a new web page will pop up and link to your device accordingly.
You will see that DIPS is a much easier service than DDNS.
Device Title:
You can enter the name of this unit here. It’s very useful to identify the specific device from
multiple units. The information will be shown on IPWizard II once the device is found.