Brady PAM 3000 - Manual (Page 31)

31 Printer-Applicator-System PAM 3000
8 Adjustments
All supplied label applicators have passed a previous run at the factory. Therefore, the basic
adjustments which are necessary for the operation of the device have been carried out.
It may be useful to do some more fine tuning when the applicator is installed. This refers
mainly to mechanical parameters, which are depending on the format of the labels as well as
some special settings for the type of operation.
Mechanical Adjustments
Adjusting the Level of the Lift Cylinder Unit
There are three screws at the front side of the applicator to adjust the level of the cylinder unit.
1. Loosen the two screws (1) at the carrier plate of the applicator. But they may not be
removed.
2. Move the whole unit within the longish holes (2) by screwing the screw (3).
The pad has to be located slightly above the dispense table of the printer.
3. Tighten the screws (1).
Fig. 8a Level adjustment
2
1
3
1
2