Brady PAM 3000 - Manual (Page 56)

Printer-Applicator-System PAM 3000 56
Service Unit
It is very important for operating with the PAM 3000 System to guarantee a constant pressure
of the compressed air and to use only filtered compressed air. Therefore it is recommended
to use a service unit to adjust and to filter the air.
Two variations of service units are offered. The first variation is only to use for filtering and
adjusting the compressed air. The second variation is additionally equipped with a start-up
valve. This valve guarantees a soft flow of compressed air into the system.
A connector for the compressed air supply (1) is located at both variations of service units.
The connector is suitable for a 1/4" coupling plug.
Fig. 14h Service unit - variation 1 Fig. 14i Service unit - variation 2
1 1
2 2 2 2
Fig. 14k Mounting the service unit
3
3
It is recommended to fix the service unit at the mounting plate of the printer. For that purpose
there are two holes (4) in the mounting plate and two holes (2) in the plate of the service unit.
The service unit can be mounted at the plate using the two screws included in its delivery
contents.
Following the service unit has to connect to the printer (5) at one side (3) and to the
compressed air supply at the other side (1).
4
5
4