Brady PAM 3000 - Manual (Page 45)

45 Printer-Applicator-System PAM 3000
Fig. 13b Power supply
Switch on the Printer
NOTICE !
Check all external connections before starting to print.
• Make sure that the media is loaded corresponding to the instructions.
• Check that the transfer ribbon is loaded properly before starting to print.
CAUTION !
Make sure that the slide valve of the lift cylinder is closed during operation (see
chapter 5). Otherwise the lift cylinder can be moved without control. This fact can
cause damages.
NOTICE !
Make sure that the pad is not covered by a label when switching on the device.
• Switch on the compressed air supply.
• Switch on the power supply (2) of the Printer-Applicator-System.
The printer carries out a short system test and following the display shows the system mode
"ONLINE". If a hardware failure occurs during the system test the type of the failure will be
shown. In this case the printer should be switched off and on again. If the failure occurs
again call for service.
If the display is not showing anything after switching on the printer, please check the following:
- the connection of the power cord is correct
- the fuse (1) that protects the power connection, is not defective
2
1