AirLive Ether-GSH24TW - Manual (Page 16)

16
Identifying External Components
This chapter describes the front panel, rear panel and LED
indicators of the Switch
Front Panel
The figure below shows the front panels of the Switch.
Figure 4. Front panel of 24-port Gigabit Ethernet Switch
LED Indicator:
Comprehensive LED indicators display the status of the switch
and the network (see the LED Indicators chapter below).
Gigabit Ethernet Ports (Port 1~24):
The Switch sixteen Gigabit twisted pair ports, supported auto
negotiable 10/100/1000Mbps and auto MDI/MDIX crossover
detection function, this function gives true “plug and play”
capability, just need to plug-in the network cable to the hub
directly and don’t care if the end node is NIC (Network Interface
Card) or switch and hub. These ports can operate in half-duplex
mode for 10/100Mbps and full- duplex mode for
10/100/1000Mbps.
Note: When the port was set to “Forced Mode”, the Auto
MDI/MDIX will be disabled.