AirLive Ether-GSH24TW - Manual (Page 27)

27
Configuring the Switch
The 24-Port 10/100/1000Mbps Gigabit Ethernet Web Smart
Switch has a Web GUI interface for smart switch configuration.
The Switch can be configured through the Web Browser. A
network administrator can manage, control and monitor the
switch from the local LAN. This section indicates how to
configure the Switch to enable its smart functions including:
‹ Port Setting (Speed/Disable, Duplex mode, Flow Control
and Port base QoS)
‹ Virtual LAN Group setting (VLAN)
‹ Trunk
‹ Port Mirroring
‹ System Setting
‹ Device status and Statistic
Login
Before you configure this device, note that when the Web Smart
Switch is configured through an Ethernet connection, make sure
the manager PC must be set on same the IP network. For
example, when the default network address of the default IP
address of the Web Smart Switch is 192.168.0.1, then the
manager PC should be set at 192.168.0.x (where x is a number
between 2 and 254), and the default subnet mask is
255.255.255.0.