AirLive N.Plug - Manual (Page 10)

1. Introduction
AirLive N.Plug User’s Manual 5
Hardware Mode Selector and USB port
AP In order switch to AP mode, User need to MANUALLY flick the
hardware switch to the line labeled AP. The device will reboot
which takes about 45 seconds. After the device has fully started, it
will automatically into the selected AP mode.
Repeater This is the DEFAULT mode when release from factory. In order
switch to Repeater mode, User need to MANUALLY flick the
hardware switch to the line labeled Repeater. The device will
reboot which takes about 45 seconds. After the device has fully
started, it will automatically into the selected Repeater mode.
Router In order switch to Router mode, User need to MANUALLY flick the
hardware switch to the line labeled Router. The device will reboot
which takes about 45 seconds. After the device has fully started, it
will automatically into the selected Router mode.
USB Port 2.0 USB port which provide access for 3G/3.5G USB dongle. For
the compatibly 3G/3.5G dongle support list, please refer to Appendix
section.
1.4.3 Bottom View