AirLive POE-FSH8PW - Manual (Page 7)

1. Introduction
AirLive POE-FSH8PW User’s Manual
2
*Note:
„ This switch does not work with 802.3af and 802.3at PoE devices. It uses 24V passive
PoE standard
„ Please make sure your device's PoE port can accept 24V passive PoE power.
1.2 Guide to the Chapters
„ Chapter 1: Introduction and Quick Setup guide. All the essential information including
IP Address and Password information are in the Quick Setup section.
„ Chapter 2: Detail installation instruction including how to make Cat. 5 Cable
„ Chapter 3: LED indicators
„ Chapter 4: Detail information on Web management including how to setup remote
management.
1.3 Quick Setup
This section provides the essential information for experienced users to operate the switch
immediately. For detailed installation instruction, please see chapter 2 for more information.
Power-On the switch
„ The POE-FSH8PW has a built-in power supply to operate with 100 ~ 240V AC, 50 ~
60Hz power source.
„ The AC power cord connector is located at the rear of the unit and the On/Off switch is
next to the connector.
„ After the Switch is powered on, it will perform “self-diagnostic” test. This process takes
about 5 seconds to complete.
LED Table
LED Status Description
PoE
On The POE function is enabled.
Off The POE function is disabled.
On Power is on. Power
Off Power is off.
On Port is for connection.
Off No connection.
Link/ACT
Flashing Data is transmitting or receiving