AirLive WLA-5000AP v3 - Manual (Page 29)

AirLive WLA-5000AP v3 Firmware 2.x User’s Manual
23
3.2.3 SNMP Settings
Advanced Settings>>SNMP Settings
This screen allows you to configure SNMP parameters including the system name, the location and contact
information.
System Name: A name that you assign to your 802.11a+g Router. It is an alphanumeric string of up to 30
characters.
System Location: Enter a system location.
System Contact: Contact information for the system administrator responsible for managing your 802.11a+g
Router. It is an alphanumeric string of up to 60 characters.
Community String For Read: If you intend the router to be managed from a remote SNMP management
station, you need to configure a read-only “community string” for read-only operation. The community string is
an alphanumeric string of up to 15 characters.
Community String For Write: For read-write operation, you need to configure a write “community string”.
Assign a specific name and IP address for your SNMP trap manager:
A trap manager is a remote SNMP management station where special SNMP trap messages are generated
(by the router) and sent to in the network.