2 wisp router dhcp server settings – AirLive WLA-5000AP v3 User Manual
Page 52
Advertising
AirLive WLA-5000AP v3 Firmware 2.x User’s Manual
46
3.8.2 WISP Router DHCP Server Settings
Advanced Setting >> DHCP server Setting
DHCP stands for Dynamic Host Configuration Protocol. The DHCP server dynamically assigns IP addresses
(from a pre-defined list) to clients when they log on. The client will request a new IP when the specific period of
time is about to run out. If it expires, the address is returned to the pool of IP addresses.
Under WISP mode, select the check box of “Enable DHCP Server” to enable DHCP server function.
The range of Clients’ IP addresses is from 192.168.1.2 to 192.168.1.254.
You can assign an IP address to a specified MAC address.
Advertising