AirLive WN-300PCI - Manual (Page 30)

26
Item Name
Description
EAP Method Select 802.1x EAP method from dropdown menu. Please ask the
administrator of the access point you wish to connect to select a
correct EAP method.
Tunnel
Authentication Select 802.1x tunnel authentication type from dropdown menu.
Please ask the administrator of the access point you wish to
connect to select a correct tunnel authentication method. This pull
down menu is only available when authentication type you use is
'PEAP', ‘TLS / Smart Card', or 'TTLS'.
When you use 'EAP-FAST' as authentication type, the protocol
setting is always 'Generic Token Card' and can not be changed.
You also need to select ‘Soft Token’ or ‘Static Password’ as
password in ‘ID \ Password’ setting.
’EAP Fast’ authentication type also have a sub-menu to set EAP
fast-specific parameters:
If you need to use protected authentication credential, check ‘Use
protected authentication credential’ box, and click ‘Import’ to
load .pac credential file; to remove a loaded credential file, click
‘Remove’.
Session
Resumption You can enable or disable session resumption here. If you don’t
know if you should enable session resumption or not, please ask
your 802.1x authentication administrator.
ID \ Password
tab Input 802.1x username (ID) and password and other information if
it is required here. Click ‘Show Password’ to show the password
you typed.
Client
Certification tab Use this tab to select a local certificate from dropdown menu. If
the access point you wish to connect required a specific client
certificate, the certificate must be installed on your computer, and