Autoquip GATES SLIDING - Manual (Page 2)

1
INTRODUCTION
___________________________________________________________
The gates you are about to install are made of durable, high quality expanded metal. They are
fabricated from 13 gauge expanded metal and will provide sturdy and secure protection for the
equipment. These gates and enclosures also conform to ANSI Standard B20.1b
NOTE:
Gates are identified as either lock left or lock right. That is, as you are standing outside the
enclosure facing gate, a lock left gate will have the handle on the left, gate slides from the right
to left to close. Lock right , as you are standing outside the enclosure facing gate, a lock right
gate will have the handle on the right , gate slides from the left to right to close.
TABLE OF CONTENTS
Introduction..................................……………………………………………………….........….1
Tool Requirements.............................................................................................................. 2
Slide gate installation, single panel ...................................................................................3
Enclosure installation.......................................................................................................….7
Interlock installation
Solenoid....................................................................................................................9
G.A.L.........................................................................................................................13
Option installation
Ramp...............................................................................................................…......16
ITEMS TO BE SUPPLIED BY INSTALLER:
(12 per gate) 3/8” x 3 ½” (min.) ANCHOR BOLTS
(20 per level ) 3/8” x 3 ½” (min.) ANCHOR BOLTS, AMOUNT WILL DEPEND
ON ARRANGEMENT.
MISCELLANEOUS SUPPORT BRACING (ANGLE OR CHANNEL) AS
REQUIRED.