Autoquip GATES SLIDING - Manual (Page 7)

6
____________________________________________________________
12. When each post is plumb, determine the distance between the gate and the “I” beams of the lift.
Cut (2) support braces and weld in place. (1-1/2 x 1-1/2 x 1/8 angle or equivalent material.)
CAUTION!!! MAKE SURE THAT FINAL BRACING DOES NOT INTERFERE WITH
THE LIFT PLATFORM OR ANY OF IT’S MOVABLE COMPONENTS.
13. Check for the proper gate operation by opening and closing the gate. When it operates smoothly
tighten all the bolts. You will also need to weld the bottom gate track angle to the middle post.
Bottom Track Angle Welded to Middle Post
14. Install the required interlock according to the instructions.
15. Install the Warning Decals on the gate panel and post. (See PAGE 7 for location.)