Autoquip GATES SLIDING - Manual (Page 9)

8
ENCLOSURE INSTALLATION
___________________________________________________________
To install enclosure panels you must look at the plan views on the Lift approval drawing to see the
basic layout of the panels. Compare the enclosure panel length measurement to the drawing. If the Lift
approval drawing calls for full height enclosures they will be labeled for each level. You can follow
these drawings for assembly of the full height enclosures.
The easiest way to assemble the enclosure panels is to start at one side of the gate and work your way
around the lift. NOTE: If space allows, you can assemble each side, then stand the completed side up.
NOTE: The enclosure panels that attach to the floor will have “feet” for lagging them to
the floor. For ease of installation do not lag the enclosures until you have assembled all
of the enclosures.
1. Find the first panel that goes on the right side of the gate. This will most likely be a filler panel. Use
TEK screws to attach panel to the gate post angle clips.
2. The next panel will connect to the first panel. In most cases, this will be a corner. Use (3) 3” long
corner angles and TEK screws, to attach panels at corner. (See figure 7)
Corner Angles
FIGURE 7