Autoquip GATES SLIDING - Manual (Page 6)

5
____________________________________________________________
Figure 2
7. The preferred location of the gate is (6) inches maximum from the face of the carriage. This
distance may vary from 4 to 6 inches.
8. When the gate position is determined, snap a chalk line parallel with the front edge of the platform
at the required distance.
NOTE: Floor openings and enclosure layouts may effect actual gate location. Refer to the
general arrangement drawing and double check actual site conditions.
9. Carefully raise the gate assembly. The trolley channel and gate panel are to be on the outside
(away from lift). Align the center of the Sliding gate panel with the carriage centerline, and parallel with
the carriage.
PLATFORM SIDE
10. With 3/8” anchor bolts at least 3” long, anchor each post.
Hint: Make sure that the hole depth is at least equal to the length of the anchor. You may also
want to use only two anchors per post until the remainder of the installation is complete.
11. Using a plumb line or 4’ level plumb and plumb each post.
Slide Gate Installation (Cont.)