BAND-IT BT1000 Boss Tool - Manual (Page 6)

BT1000
BOSS TM Tool
www.band-it-idex.com
Document # P98750 Rev. B
© Copyright
BAND-IT-IDEX, Inc. 2013
All rights reserved Page 6
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Operating Manual
BT1000 BOSS TM Tool Manual
Operation
1. Feeding the band (strap)
Feed the band through the seal, around the parts/object to be
strapped and again through the seal.
The band end is then bent. The operator then tensions the
loose loop manually making sure that the bent end is adjacent
to the object to be strapped.
Always wear
safety glasses Always wear
protective gloves
when handling
band/ strap
2. Inserting the tool
The upper band is held with the left hand; the right hand lifts the
air motor and insert the tool from the right to the left and from
the rear to the front. The air motor is then released.