Operating manual – BAND-IT BT1000 Boss Tool User Manual
Page 8
BT1000
BOSS
TM
Tool
www.band-it-idex.com
Document # P98750 Rev. B
©
Copyright
BAND-IT-IDEX, Inc. 2013
All rights reserved
Page 8
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Operating Manual
BT1000 BOSS
TM
Tool Manual
Operation
5. Releasing the tool
The tool can now be released from the strapping without any
further action after completing the strapping cycle. By lifting
the air motor, the band end is removed from the tool.
6. Tension adjustment
The tension can be adjusted by adjusting the throttle screw. The air
supply is reduced by turning the screw clockwise, hence reducing
the tension.
The throttle screw is located at the rear end of the air motor.
Note: The tool tension speed has been factory set to maximum.