It1000-ab, Setup & assembly instructions, 11 of 38 – BAND-IT IT1000-AB 1/4 Tie-Lok Tool User Manual

Page 11: 1/4” tie-lok, Tool

Advertising
background image

Document # I17791 Rev H

© Copyright

BAND-IT-IDEX, Inc. 2009

All rights reserved

www.BAND-IT-IDEX.com

BAND-IT-IDEX, Inc.

A Unit of IDEX Corporation

4799 Dahlia Street Denver, CO 80216-0307 USA

P: 1-800-525-0758 F: 1-800-624-3925

11 of 38

IT1000-AB

1/4” Tie-Lok

®

Tool

Part of insuring that the tool is producing a strong lock is making sure that it approaches
the application correctly and is fixtured to allow repeatability of application. The tool
should approach the surface tangent to where the buckle of the band is to be applied.
The tool should be allowed to float 1/8” – 1/4” above the surface to allow the buckle to
move to the proper position for cut-off. Once the tool begins tensioning, the band will
pull the tool down to the surface.

Buckle Location

Pivot Point

As the band is tensioning, the tool may rotate clockwise up to 5 degrees about the pivot
point (Green Arrow). During the cut-off cycle, the tool must be allowed to rotate counter-
clockwise up to 35 degrees (Blue Arrow). Because of this movement, BAND-IT
recommends that the tool be mounted in a fixture that will provide adequate
rotation during both cycles.

1/8” – 1/4”

Setup &
Assembly
Instructions

Advertising