It1000-ab, Setup & assembly instructions, 9 of 38 – BAND-IT IT1000-AB 1/4 Tie-Lok Tool User Manual
Page 9: 1/4” tie-lok, Tool
Document # I17791 Rev H
© Copyright
BAND-IT-IDEX, Inc. 2009
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-0307 USA
P: 1-800-525-0758 F: 1-800-624-3925
9 of 38
IT1000-AB
1/4” Tie-Lok
®
Tool
Handle adjustment:
• Using 1/4” hex key (supplied), adjust
the Support Arm/Handle to
ergonomically match the operator’s
hand.
• Be sure not to adjust the Handle too far
outward (beyond interlocking legs) or
the handle will not function properly or
provide support to the operator.
Hanger Support Instructions:
1. An aluminum hanger (accessory)
can be utilized for supporting the
tool.
2.
The hanger should be installed (as
shown) into the two threaded holes.
3.
Secure the hanger against the tool
body with the two supplied screws.
4.
A light application of vibratite is
already included on the screw’s
thread.
Hanger Mount
Setup &
Assembly
Instructions