BAND-IT S100 Classic Air Tool - Manual (Page 13)

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # P09287 rev. L
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
www.BAND-IT-IDEX.com
Page 13 of 18
S10099
Classic Air Tool
Refer to website for warranty information:
http://www.band-it-idex.com/warranty.html
Maintenance List
Warranty
MAINTENANCE CHECK LIST
COMPONENT CHECK ACTION FREQUENCY
CLAMP HEAD
CHECK FOR LOOSE
MOUNTING SCREWS. TIGHTEN ALL SCREWS AND
FASTENERS.
DAILY
CUTTER BLADE AND
BACKING PLATE
CHECK TO SEE IF BLADE
IS LOOSE OR HAS ANY
BROKEN OR CHIPPED
EDGES.
TIGHTEN ALL SCREWS AND
FASTENERS. REPLACE IF
NECESSARY.
DAILY
FILTER / LUBRICATOR
CHECK FOR BUILD-UP OF
DIRT, ETC. CHECK FOR
LOW, CONTAMINATED OR
DISCOLORED LUBRICANT.
DRAIN AND CLEAN WITH SOAP
AND WATER. REFILL WITH
DTE 24 HYDRAULIC OIL.
EVERY 2000 CLAMPS
ECCENTRIC LEVER
CHECK FOR BUILD-UP OF
DIRT, ETC., IN TEETH.
REMOVE AND CLEAN WITH
SMALL POINTED OBJECT,
KNIFE BLADE, WIRE BRUSH.
EVERY 2000 CLAMPS
CYLINDER
CHECK FOR BUILD-UP OF
DIRT, CONTAMINANTS ON
PISTON ROD SEALS.
CLEAN WITH SOAP AND WARM
WATER.
6 MONTHS
TRIPPER PLATE
CHECK FOR BUILD-UP OF
DIRT, CONTAMINANTS,
ETC.
CLEAN AND APPLY TYPE G-N
LUBRICANT OR EQUIVALENT.
6 MONTHS
AIR EXHAUST
MUFFLERS
CHECK FOR BUILD-UP OF
DIRT, CONTAMINANTS,
ETC. REMOVE AND CLEAN WITH
NON-FLAMMABLE
DEGREASER.
6 MONTHS