BAND-IT S100 Classic Air Tool - Manual (Page 3)

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # P09287 rev. L
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
www.BAND-IT-IDEX.com
Page 3 of 18
S10099
Classic Air Tool
SAFETY PROCEDURES
1. FAMILIARIZE YOURSELF WITH OPERATING
PROCEDURES BEFORE OPERATING THE S10099 AIR
TOOL.
2. DO NOT OPERATE TOOL WITHOUT SLIDE COVER IN
PLACE.
3. USE ONLY RECOMMENDED BAND-IT PREFORMED
CLAMPS OR BAND AND BUCKLE WITH THE PROPER
HEAD ASSEMBLY.
4. DO NOT EXCEED RECOMMENDED PRESSURE SETTINGS.
EXCESS PRESSURE MAY CAUSE SUDDEN CLAMP
FAILURE DURING APPLICATION OR RESULT IN AN
UNSAFE CLAMP. CERTAIN APPLICATIONS MAY REQUIRE
A REDUCED PRESSURE SETTING. SEE PAGE 6 FOR
RECOMMENDED PRESSURE SETTINGS. ALSO SEE PAGE
6 FOR IMPORTANT ADVICE AND WARNINGS.
5. ALWAYS KEEP FINGERS CLEAR OF CLAMP DURING
APPLICATION.
6. DISCONNECT AIR SUPPLY BEFORE SERVICING AIR
TOOL.
7. TOOL MUST BE FIRMLY MOUNTED (SEE INSTALLATION
INSTRUCTIONS ON PAGE 4).
8. SAFETY CLASSES OR GOGGLES SHOULD BE WORN
WHEN APPLYING CLAMPS.
9. ALWAYS KEEP TOOL IN GOOD OPERATING CONDITION.
AIR LINE REQUIREMENTS
AIR LINE PRESSURE: 100 PSI MINIMUM, 150 PSI MAXIMUM (7.0 – 10.5 kg/cm 2 , 689 – 1034 kPa)
CONSUMPTION: 3-5 CFM WITH 20 GALLON TANK MIN.
LINE SIZE: 1/4” ID MINIMUM
CONNECTION: 1/4” NPT
FILTER / LUBRICATOR:
MUST BE ADDED TO AIR SUPPLY. SEE PAGE 18 FOR BAND-IT FILTER /
LUBRICATION KIT
Specifications
and Safety
OVERALL DIMENSIONS: 20 ¼” LONG
9 7/8” WIDE
13 ¼” HIGH
SHIPPING WEIGHT: 42.5 LBS. CONTROL LEVER
PULL SPEED CONTROL
SLIDE COVER
CUT OFF HANDLE
JUNIOR CLAMP HEAD
AIR SUPPLY INLET
PRESSURE SETTING
CHART
PRESSURE SETTING CONTROL