BAND-IT S100 Classic Air Tool - Manual (Page 4)

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # P09287 rev. L
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
www.BAND-IT-IDEX.com
Page 4 of 18
S10099
Classic Air Tool
Inspection and
Installation
INSPECTION
WHEN REMOVING AIR TOOL FROM SHIPPING CARTON, CHECK FOR
SHIPPING DAMAGE WHICH SHOULD BE REPORTED TO THE CARRIER.
INSTALLATION
1. RECOMMENDED TABLE HEIGHT IS 34” TO 40”. THIS IS THE OPTIMUM RANGE FOR APPLYING CLAMPS TO MOST ITEMS.
MAKE SURE THE INSIDE CLEARANCE IS ADEQUATE FOR ITEMS TO BE CLAMPED.
2.
THE AIR TOOL MUST BE FIRMLY SECURED TO WORK BENCH. USE 5/16” DIAMETER FASTENING HARDWARE (NOT SUPPLIED
WITH AIR TOOL). AIR TOOL MAY BE MOUNTED ON AN OPTIONAL 12° INCLINE BASE (SEE PAGE 18).
3.
THE INCOMING AIR SUPPLY MUST COME THROUGH A FILTER/LUBRICATOR, LOCATED NO MORE THAN 30” FROM AIR TOOL
(SEE PAGE 17 FOR BAND-IT FILTER / LUBRICATOR KIT).
USE OF THE S10099 AIR TOOL WITHOUT A FILTER / LUBRICATOR VOIDS THE WARRANTY