Carbolite ABA 7/35B - Manual (Page 60)

60 MF60 – 1.04
21.12 Catch Tray Straightening
The stresses caused by repeated heating and cooling can cause the catch tray (Fig: 2.2.2) to
distort, allowing the catch tray to rock in use, giving an unstable balance reading. The distortion
takes the form of two opposite corners bending up and the other two opposite corners bending
down.
Straighten the tray by resting the two lower corners on supports, and pressing down on the
higher corners. Repeat this operation until the tray is flat.
21.13 Consumables
Printer Paper: standard till roll paper 2¼ ’ (57mm) wide Carbolite part number 22-222-356-0010.
Printer Ribbon: Epson ERC-09.