Bosch 4405 - Manual (Page 16)

16.
Adjustments
Miter Scale
Indicator Adjustment
1. Rotate table to 0° position and lock in place.
2. Raise the head assembly to the full-up position.
3. Loosen the Phillips screw that holds the indica-
tor in place (Figure 15).
4. Position the indicator to align with the 0° miter
mark. Tighten the screw.
Blade Square to Fence
Fence Alignment Check
1. Make sure head assembly is pulled forward near
the center of the table and slide rail lock knob is
tightened (Figure 13).
2. Lower the head assembly, and lock in the
lower position.
3. Make sure table is in 0° detent and tighten miter
lock knob.
4. Place a combination square against the fence
and next to the blade as illustrated. Locate the
square properly so it does not contact the tooth
of saw blade. The saw blade should contact the
full length of the square (Figure 13).
5. If blade does not contact the square, follow the
fence alignment procedure.
Figure 13. Blade Square to Fence
Fence Alignment Adjustment
1. The head assembly should remain in lowered
position.
2. Extend sliding fence. Use blade wrench (sup-
plied) and loosen three (3) bolts behind fence
(Figure 14).
3. Adjust fence until blade and the fence has full
contact with the square.
4. Tighten hex cap screws.
Figure 14. Fence Adjustment
(Back view of table/base area)
Miter Lock
Knob
Slide Rail Unit
Slide Rail
Lock Knob
Figure 15.
Indicator
Screw 0º Mark
Hex Cap Screws
Fence