Bosch 4405 - Manual (Page 30)

30.
Crown Molding Angled to
Table and Fence
• The advantage to cutting in this position is that
no bevel setting is required. Cutting is done with
45° miter angle.
• The maximum crown molding width that can be
cut and angled to table and fence is 4-1/4". The
preferred method for cutting crown molding with
this saw is with the molding laying flat on the
table at a maximum width of 10”. Crown stops
can be purchased as an accessory.
Follow these instructions for cutting crown
molding angled to table and fence.
1. Position the molding so the bottom (part which
is installed against the wall) is against the fence.
2. Set the miter angle using Chart 2. Tighten the
miter lock knob (Figure 34).
3. Support crown molding against the fence (see
“Body and Hand Position” on page 19.)
4. Follow the procedures for chop or slide cut (see
page 24).
Figure 34. Crown Molding Angled to
Table and Fence
5. Wait until blade comes to a complete stop
before returning head assembly to the raised
position and/or removing workpiece.
NOTE: ALWAYS TAKE A TEST CUT USING
SCRAP TO CONFIRM CORRECT ANGLES.
Saw Operations
CROWN MOLDING CUTS - CUTTING METHOD #2 - ANGLED TO TABLE AND FENCE
MAX. SIZE: 4- 1 / 4 "
TYPE MITER BEVEL TYPE MITER BEVEL
OF (TABLE) (TILT) OF (TABLE) (TILT)
CUT SETTNING SETTING CUT SETTNING SETTING
INSIDE CORNER
RIGHT
OUTSIDE CORNER
RIGHT
LEFT SIDE 45º 0º LEFT SIDE 45º 0º
SAVE RIGHT END OF CUT SAVE RIGHT END OF CUT
LEFT LEFT
RIGHT SIDE 45º 0º RIGHT SIDE 45º 0º
SAVE LEFT END OF CUT SAVE LEFT END OF CUT
D B
C A
52º CEILING
OUTSIDE
CORNER
INSIDE
CORNER ANGLES OF U.S.
STANDARD MOLDING TABLE
38º
W
A
L
L
F
E
N
C
E
BOTTOM EDGE
52º
A B
C
D