CHAMPION EUCC Series - Manual (Page 41)

33
13. RECHECK THE BELT TENSION IN 3 WEEKS
AND ADJUST TO COMPENSATE FOR BELT
STRETCH.
14. DO NOT OVERTIGHTEN THE BELT.
15. Locate the conveyor belt drive assembly
located at the unload end of the dishwasher.
16. Refer to the photos on the right and note the
arrangement of the drive clutch components.
18. Locate the clutch kit included in the
hardware kit and install the components as
shown. Tighten the clutch retaining nut.
19. Proper clutch adjustment is correct if a
185lbs. person can stall the belt when they pull
against a moving belt
20. The installation is close to completion.
_________ Installation Instructions

Section Assembly
Section Assemby
1 HUB,TORQUE LIMITER #350A 1
2 FRICTION DISC, #350A CLUTCH 2
3 PRESSURE PLATE, #350A TORQUE LIMITER 1
4 SPRING WASHER, #350A TORQUE LIMITER 2
5 LOCKWASHER, #350A TORQUE LIMITER 1
6 ADJUSTING NUT, #350A TORQUE LIMITER 1
7 BUSHING, #350A TORQUE 1
8 SPROCKET, TORQUE LIMITER, 350AG26 1
1
2
8
7
3
4
4
5
6