Brother HL 3070CW - Manual (Page 118)

Control panel features
108
8
Network menu
8
Before using your Brother product in a network environment, you need to configure the correct TCP/IP
settings.
In this section, you will learn how to configure the network settings using the control panel, located on the
front of the machine.
The Network menu selections of the control panel allow you to set up the Brother machine for your network
configuration. Press any of the Menu buttons (+, -, OK or Back) to display the main menu. Then press + or -
to choose Network. Proceed to the menu selection you wish to configure. For additional infomation on the
menu see Function table and factory default settings on page 195.
Please note that the machine is supplied with the BRAdmin Light utility and Web Based Management (web
browser), which also can be used to configure many aspects of the network. See Changing the print server
settings on page 16.
TCP/IP
8
This menu has 7 sections: Boot Method, IP Address, Subnet Mask, Gateway, IP Boot Tries, APIPA
and IPv6.
Boot Method
8
This selection controls how the machine obtains an IP address. The default setting is Auto.
Note
If you do not want your print server configured via DHCP, BOOTP or RARP, you must set the Boot Method
to Static so that the print server has a static IP address. This will prevent the print server from trying to
obtain an IP address from any of these systems. To change the Boot Method, use the machine’s control
panel, BRAdmin Light utility or Web Based Management (web browser).
a Press any of the Menu buttons (+, -, OK or Back) of the control panel on your machine.
b Press + or - to choose Network.
Press OK.
c For HL-3070CW
(For wired) Press + or - to choose Wired LAN.
(For wireless) Press + or - to choose WLAN.
Press OK.
d Press + or - to choose TCP/IP.
Press OK.
e
Press + or - to choose Boot Method.
Press OK.