Brother HL 3070CW - Manual (Page 99)

Wireless configuration using SES/WPS or AOSS from the control panel (For HL-3070CW)
89
6
How to configure your wireless machine, using SES/WPS or
AOSS from the control panel menu
6
IMPORTANT
If you are going to connect your Brother machine to your network, we recommend that you contact your
system administrator prior to installation.
If you are using Windows
®
Firewall or a firewall function of anti-spyware or antivirus applications,
temporarily disable them. Once you are sure that you can print, configure the software settings following
the instructions.
If you have previously configured the wireless settings of the printer, you must reset the print server back
to its factory default settings (see Reset the network settings to the factory default on page 122).
a Press any of the Menu buttons (+, -, OK or Back) of the control panel on your machine.
b Press + or - to choose Network.
Press OK.
c
Press + or - to choose WLAN.
Press OK.
d Press + or - to choose SES/WPS/AOSS.
Press OK.
Note
If your wireless access point supports Wi-Fi Protected Setup (PIN Method) and you want to configure your
machine using the PIN (Personal Identification Number) Method, see How to configure your wireless
machine, using the PIN Method of Wi-Fi Protected Setup on page 98.
e
The machine searches for an access point that supports SecureEasySetup™, Wi-Fi Protected Setup or
AOSS™ for 2 minutes.
f
Put your access point in the SecureEasySetup™ mode, Wi-Fi Protected Setup mode or AOSS™ mode,
depending on what is supported by your access point. Please refer to the instruction manual that came
with your access point.