COATS 6200HS Truck Wheel Balancer User Manual
Page 20
14
Coats Model 6200HS
Static Balancing:
For this method, only LED 3 lights
to indicate a single clip-on or stick-on weight. The weight
can be positioned on the inner or outer rim flange, or
towards the center of the rim. If the imbalance is large,
the amount of weight required can be divided equally
between the inner and outer rim flanges.
For static balancing, the rim width and offset dimensions
do not need to be entered into the balancer, simply
enter the wheel diameter. After the measuring cycle,
the inner arrow LED’s and TDC indicators will light to
show the required weight amount and position.
For simple and accurate balancing, the Normal mode
can be used for all balancing measurements. After the
balancing cycle, press the Mode Select Button
repeatedly until the LED indicators light for the desired
weight locations. The balancer will automatically
recalculate the weight required for each mode.
Weight Location Dimensions for Truck
A = 1.0"/2.5cm / B = 1.5"/4cm / D = 6.0 ”/15cm