Installation – COATS 6200HS Truck Wheel Balancer User Manual
Page 5
Operation Guide
iii
INSTALLATION
Your Model 6200HS Truck Balancer and accessories
will be delivered in a single carton mounted on a pallet.
Unpacking
A. Unpack the balancer and all accessories.
B. Check the contents list below and confirm that
all parts are present. Check also for the
standard wheel mounting accessories and any
optional accessories you may have ordered.
Qty
Item
1
Balancer assembly.
1
Stub shaft and bolt.
1
Plug-in power converter.
1
Light truck cone.
1
Medium truck cone.
1
Large truck cone.
1
Rim width Callipers.
1
Spacer Ring.
1
Hub nut assembly.
1
Operators manual.
Assembly
Tools required : 10mm and ½” spanner
Philips screwdriver
9/16 thin wall socket
1. Place the balancer on a firm solid floor.
2. Fix the stub shaft to the spindle, by inserting the
bolt and 2 washers then tightening to a torque of
30Nm (110Ibsin -130Ibsin) using a 9/16 thin wall
socket.
3. Verify the correct voltage is shown on the product
serial label and the power converter supplied. Plug
the power converter into the mains outlet. Connect
the power converter cord to the input connector at
the rear of the balancer measuring head. The
balancer beeps and is switched on.
Your balancer is now ready for use!