COATS 6200HS Truck Wheel Balancer User Manual
Page 33
Operation Guide
27
and shows 0 - 10 grams (0 - 0.25 ounces) for the
side without the weight. If the readings are not within
these limits, verify that the wheel dimensions are
set correctly and perform the CALIBRA TION
procedure, before proceeding to the next step.
6. Remove the 100-gram (3-ounce) weight and verify
that the wheel is balanced in Fine Mode.
7. Rotate the wheel 180
o
in relation to the mounting
flange and re-spin. The sum of the inner and outer
readings should be a maximum of 15 grams (0.50
ounces) for a 14" or smaller wheel. If the sum is
higher, make sure the wheel is properly centered
when tightening the hub nut. Clean the mounting
surface, spindle, cones and wheel, and then repeat
the check. If the new sum is also too high, repeat
the check with a new wheel.
If the balancer fails any of the above
steps, contact your service representative
for assistance in correcting the problem.