Daisy PowerLine 693 - Manual (Page 3)

PRIOR TO OPERATION
Put “ON” SAFETY–POSITION SAFETY LEVER TOWARDS “SAFE”
(refer to Operation Step 1, page 4).
OPERATION STEPS:
WARNING: Be sure gun is always pointed in a safe direction.
If desired, the gun may continue to be fired (Steps 5 and 7) until the Quick
Change BB Clip is empty or the CO
2
cylinder needs to be replaced. Once the Quick
Change BB Clip is empty, Steps 1,3,4,5,6,7, and 8 should be followed. If the CO
2
cylinder is empty, then all 8 Steps should be followed. (Approximately 10 Quick
Change Clips or 150 shots can be expected per cylinder).
NEVER STORE A LOADED GUN
At the end of a shooting session, as a safety precaution, always put “ON” safety
(refer to step 1, page 4), remove CO 2 cylinder (refer to page 9) and remove Quick
Change BB clip from pistol (refer to page 9). Store in a safe place to prevent
unauthorized use.
3
Step 1. PUT “ON “ SAFETY – POSITION SAFETY
LEVER TOWARDS “SAFE” (refer to
page 4).
Step 2. INSERT CO 2 CYLINDER (refer to page 4).
Step 3. FILL QUICK CHANGE BB CLIP WITH A
MAXIMUM OF 15 BBs (refer to page 5).
Step 4. INSERT QUICK CHANGE BB CLIP INTO
GUN (refer to page 6).
Step 5. AIM AT A SAFE TARGET (refer to page 7).
Step 6. TAKE “OFF” SAFETY – POSITION
SAFETY LEVER TOWARDS “FIRE” (refer
to page 7).
Step 7. FIRE (refer to page 8).
Step 8. PUT “ON” SAFETY.
REMOVABLE QUICK
CHANGE BB CLIP
CLIP
RELEASE
LATCH
REAR SIGHT
FIG. 1B