Daisy PowerLine 693 User Manual

Page 5

Advertising
background image

6. With muzzle pointed in a safe direction, turn puncture

screw clockwise to puncture the CO

2

cylinder (see Fig. 5).

Continue turning RAPIDLY until finger tight.

NOTE: A slight seepage of gas may occur until puncture
screw is tight.
NOTE: REPLACE LEFT GRIP COVER BEFORE
TIGHTENING PUNCTURE SCREW.
NOTE: We recommend the use of Daisy

®

Max Speed™

12gm CO

2

cylinders.They are made to fit the Model 93/693.

Other sizes of CO

2

cylinders may not fit properly and if you

force them into place, it may result in injury to someone or damage to your pistol.
Never try to force any CO

2

cylinder into place.

STEP 3. FILL QUICK CHANGE BB CLIP WITH A MAXIMUM OF 15 BBs
1. Remove the empty Quick Change

Clip from the gun. This is
accomplished by pushing the Quick
Change Clip release latch rearward.
This will Cause the rear end of the
Quick Change Clip to pop up out of
the gun. The Quick Change Clip can
then be fully removed from the gun
by lifting up on the rearward portion
of the Quick Change Clip (see Figs. 6
and 6A).

2. Move the Quick Change Clip follower

back and lock into position as shown
in Fig. 7. (Front end of Quick Change
Clip should always be inserted into
the gun first to insure proper
operation.)

5

FIG. 5

PUNCTURE
SCREW

FIG. 7

FIG. 6

FIG. 6A

QUICK CHANGE
CLIP

QUICK
CHANGE
CLIP
RELEASE
LATCH

QUICK CHANGE
CLIP FOLLOWER

QUICK CHANGE
CLIP FOLLOWER

Advertising
This manual is related to the following products: