Daisy PowerLine 693 - Manual (Page 4)

HOW TO OPERATE
WARNING: BE SURE GUN IS ALWAYS POINTED
IN A SAFE DIRECTION. NEVER POINT THE GUN AT
ANYONE. ALWAYS ASSUME AND TREAT THE GUN
AS IF IT WERE LOADED AND READY TO FIRE.
STEP 1. PUT “ON”SAFETY – POSITION SAFETY
LEVER TOWARDS “SAFE”
Rotate the safety lever counterclockwise toward the
“SAFE” position (see Fig. 2). In this position, the trigger
cannot be pulled to fire the gun.
CAUTION: Even when the safety is “ON” you should
continue to handle the pistol safely. Don’t point the gun at
anything that you don’t intend to shoot.
NOTE: The safety is not automatic. It will only do its job
when you do yours. With the index finger out of the
trigger area, move the safety lever to the “SAFE” position
(see Figs. 2 and 2A).
REMEMBER, THE
BEST SAFETY IS GOOD GUN HANDLING.
STEP 2. INSERT CO2 CYLINDER
WARNING: Use only CO2 cylinders which are the 12 gram type. Any attempt to
use other sizes and/or cylinders containing other types of gas could be extremely
dangerous. The use of gases other than CO2
could result in an explosion or could rupture the
gun, causing serious injury.
1. Always point gun in a safe direction. Put “ON”
safety – position safety lever towards “SAFE”
(see Operation Step 1, page 4).
2. Remove left grip cover by lifting at the bottom
of the grip (see Fig. 3).
3. Turn puncture screw counterclockwise until
there is enough room to insert a CO2 cylinder.
4. Insert the CO2 cylinder into the grip, first
placing the larger end of the CO2 cylinder into
the lower portion of the grip (see
Fig. 4).
5. Replace the left grip cover.
FIG. 4
FIG. 3
LEFT GRIP
COVER
12gm CO 2
CYLINDER
4
FIG. 2A
FIG. 2