Daisy PowerLine 693 - Manual (Page 9)

HOW TO UNLOAD
After a shooting is complete, the gun should be unloaded before storing it. To
unload the gun always put “ON” safety, remove the CO
2
cylinder, and remove the
Quick Change BB Clip. See details below.
CAUTION: Even though you have gone through an unloading procedure,
continue to treat the gun gun as though it were loaded. Don’t point at anything you
don’t intend to shoot. Always put “ON” safety – position safety lever towards “SAFE”
until you are ready to fire.
REMOVE CO
2
CYLINDER
1. Put “ON” safety – position safety lever towards “SAFE”
(see Operation Step 1, page 4).
2. With the muzzle pointed in a safe direction and the left-
hand grip cover still in place, slowly turn puncture screw
counterclockwise allowing any remaining gas to be
discharged and continue turning screw until end stop is
reached (see Fig. 15).
3. Remove left-hand grip cover by lifting at the bottom of
the grip.
4. Remove and properly dispose of CO 2 cylinder.
CAUTION: Never attempt to reuse a cylinder for any purpose.
REMOVE QUICK CHANGE BB CLIP
1. Put “ON” safety – position safety lever towards
“SAFE” (see Operation Step 1, page 4).
2. Push Quick Change Clip release latch rearward.
This will cause the rear end of the Quick Change
Clip to pop up out of the gun. The Quick Change
Clip can then be fully removed from the gun by
lifting up on the rearward portion of the Quick
Change Clip (see Fig. 6 and 6A on page 5).
3. Look inside the slot on top of the gun from which
the clip was removed. If a BB is visible,use a
ballpoint pen, screwdriver, etc. to
remove the BB from the gun as shown in Fig. 16.
CAUTION: Do not assume that the gun is empty of BBs when the Quick
Change BB Clip is removed from the gun. Verify that all BBs are removed as
illustrated in Fig. 16.
9
FIG. 16
FIG. 15