Dascom 7010 PrintServer Manual - Manual (Page 160)

Maintenance
Print Server User Manual 160
Standard Update via FTP
You can perform a standard update via an FTP connection.
Proceed as follows:
1. Change to the directory where the update file is located.
2. Open an FTP connection to the print server:
Syntax: ftp <IP address of the print server>
Example: ftp 192.168.0.123
3. Enter an arbitrary user name.
4. Enter either the print server password or press ENTER if no
password has been assigned.
5. Switch to binary mode:
bin
6. Send the update file to the print server:
Syntax: put <name of update file> binfile
Example: put a-fw-ps-12.bin binfile
7. Close the FTP connection:
quit
Dynamic Update via the PRINTSERVER Homepage
Specify a directory on the file server for automatic (dynamic)
updates. The directory contains the current software files.
Requirements
;
The file server on which the software files are stored either uses
the 'anonymous login' or the print server is set up as 'user' on
the file server.
Proceed as follows:
1. Start the PRINTSERVER Homepage.
2. Select Actions – Download Area.
3. Select Dynamic Firmware Update.
4. Tick Dynamic Firmware Update.
5. Specify the IP address of the file server on which the new
software files are to be stored.
Syntax:
ftp://<file server IP address>/