Dascom 7010 PrintServer Manual - Manual (Page 21)

Saving the IP Address in the Print Server
Print Server User Manual 21
2.5 ... via the IP Wizard (PRINTSERVER-NetTool)
The IP Wizard of the PRINTSERVER-NetTool helps you to configure
the TCP/IP parameters, e.g. the IP address. You can easily enter the
desired IP address and save it in the print server using the IP Wizard.
Requirements
;
The PRINTSERVER-NetTool is installed on the client; see:
Ö
27.
;
The network scan via Multicast has been enabled in the
PRINTSERVER-NetTool; see:
Ö
32.
;
The router in the network forwards multicast requests; see:
Ö
32.
Proceed as follows:
1. Start the PRINTSERVER-NetTool.
2. Select the print server from the print server list.
The print server is displayed in the print server list under 'ZeroConf' with an IP
address from the address range (169.254.0.0/16) which is reserved for ZeroConf.
3. Select Installation – IP Wizard from the menu bar.
The IP Wizard is started.
4. Follow the instructions of the Wizard.
ª
The settings are saved.
Fig. 1: PRINTSERVER-NetTool - IP Wizard