Main unit controls, Power button, Mode select button – Eschenbach Optik Liberty Solo User Manual
Page 6: Page 6
Page 6
Rev E EN
Main Unit Controls
The Liberty Solo has the following controls. Refer to the diagram for the
position of the controls.
Mode
Select
Function
Buttons
Power
Scroll Knob
1
1
2
3
Power Button
Press to power up the unit. Press again to power off. The Liberty Solo will not
operate without the mouse camera attached; this is to prevent accidental
discharge of the battery. The unit will power off if the camera is unplugged.
The
icon indicates that no camera was found and the unit will now
power-off.
The last-used settings are stored at power off and are restored when the unit is
switched on again. Removing the power cord or the battery with the unit
powered on may corrupt the saved settings.
Mode Select Button
There are three modes of operation:
• Full-color mode for viewing photographs, images, etc.
• Positive mode, an enhanced reading mode where the foreground “ink” is
darker than the background “paper”.
• Negative mode, an enhanced reading mode where the foreground “ink”
is brighter than the background “paper”.
The Mode button will toggle between the last reading mode and full-color
mode if a few seconds elapse between presses. Repeated pressing of the Mode
button will cycle through all three modes.