ETC Source Four CE PAR EA and MCM - Manual (Page 12)

10 • CE Source FourPAR
English
Colour frame retaining clip
The colour frame holder is equipped with a spring-loaded
retaining clip that prevents colour frames and accessories from
falling out.
Important: Only hang the CE Source FourPAR with the colour
frame retaining clip in the locked position ( Figure 6 ).
Important: Use only colour frames or snoots with 170mm
inside diameter.
1. Release the retaining clip by pushing it sideways. The retaining
clip opens.
2. Insert the colour frame.
3. Press the retaining clip down until it locks into position.
Cleaning the reflector
Caution! Do not use glass and window cleaners on the
reflector. Chemicals in these cleaners will harm
the reflective coating.
Caution! Do not use paper towels or harsh materials to
wipe the reflector. These materials can scratch the
surface of the reflector.
1. Remove the lamp housing. See Installing the HPL lamp
page 7.
2. Remove the lens and safety screen so that you can access the
reflector from the front of the luminaire. See
Removing a
lens page 9.
3. Remove dust with a blast of oil free air, or wipe with a clean,
soft, lint-free cotton cloth. If this is not sufficient to remove
dust, go to step 4. Otherwise, go to step 6.
4. Dampen a clean, soft, lint-free cotton cloth with a mild, soapy
water solution and gently wipe the reflector.
5. Remove any soapy water residue with a clean, soft, lint-free
cotton cloth dampened with water.
6. Reinstall a lens and safety screen before using the luminaire.
7. To reinstall the lamp housing, center it on the reflector and the
bolt hole, then tighten the knurled bolt to secure the lamp
housing in place.
WARNING! Unplug the luminaire before attempting to
clean reflector.
Figure 6
Retaining clip in
the locked postion
CES4PAR(4Lang)Eng.fm Page 10 Tuesday, August 31, 1999 2:35 PM