ETC Source Four CE PAR EA and MCM - Manual (Page 7)

English
CE Source FourPAR • 5
CE Source FourPAR instructions
Safety warnings
The CE Source FourPAR is intended for professional use only. Read
entire User Manual before using equipment. Please note the
following safety warnings before use:
• Do not mount the CE Source FourPAR on or near a flammable surface.
• Do not operate the CE Source FourPAR without a lens installed.
• Install the safety screen before turning the luminaire on.
• Mount and support the luminaire only by the primary suspension yoke
holes. Suspend the luminaire from a hook clamp or a stand mount, using
a securely tightened steel bolt (up to 12mmØ), washer and locking nut.
• In addition to primary suspension, make sure a safety cable (Model
#400SC) or chain is attached to the secondary suspension point on the
luminaire (see page 3).
• Always hang the CE Source FourPAR with the colour frame retaining clip
in the locked position.
• Always replace the lamp if it becomes damaged or thermally deformed.
• Use the luminaire in dry locations only, where humidity does not exceed
90 percent. Luminaire is not intended for outdoor use.
• Disconnect the unit from power before all cleaning and maintenance.
• Keep the CE Source FourPAR-EA luminaire at least 2.0 meters from
anything it is shining on. Lighted objects at this distance or greater will
not exceed 90°C temperature from a projected light.
• Keep the CE Source FourPAR-MCM luminaire at least 0.9 meters away
from anything it is shining on. Lighted objects at this distance or greater
will not exceed 90°C temperature from a projected light.
• CE Source FourPAR-EA and CE Source FourPAR-MCM maximum
ambient temperature: T
a
=45°C.
• CE Source FourPAR-EA maximum exterior surface temperature:
T
max
=175°C.
• CE Source FourPAR-MCM maximum exterior surface temperature:
T
max
=270°C.
• A multilanguage label sheet is included with this manual. Affix the label
of the appropriate language over the existing warning label on the
extension yoke. Do not cover the ETC trademark or CE mark.
PAR EA
2.0m
PAR MCM
0.9m
CES4PAR(4Lang)Eng.fm Page 5 Tuesday, August 31, 1999 2:35 PM