EUCHNER AS - Manual (Page 18)

Safety Monitors - AS-i Quick Reference - 08/2014 18
3.3 Slave-Address-Tool in the Safety Monitor
This function enables setting and changing the addresses of both new and already
configured AS-i slaves.
1. Press OK-button
2. Select SLAVE ADR TOOL and press OK-button
3. Select AS-I circuit in which is the Slave and press OK-button
4. Select CONNECT NEW SLV and press OK-button
5. Edit old and new address by OK-button
6. Select PRG and press OK-button
1 OFF 2 OFF
3 OFF 4 OFF
PROFIBUS
QUICK SETUP
AS-I SAFETY
DIAGNOSIS
SLAVE ADR TOOL
TEST
SETUP
DISP CONTRAST
SLAVE ADR TOOL
CONNECT NEW SLV
OLD ADDRESS
NEW ADDRESS
AS-I CIRCUIT 1
AS-I CIRCUIT 2
SLAVE ADR TOOL
OLD ADDRESS
5
NEW ADDRESS 17
PRG